33
Resuming operations from Standby mode
After several minutes of inactivity, the printer will enter Standby mode. During Standby, the head
temperature will decrease to conserve energy.
From the display panel press Resume.
Updating printer firmware:
Check http://www.dimensionprinting.com/uprint/customerinfo.html for printer firmware updates.
If there is an upgrade to the printer firmware, download the upgrade and install on the printer.
Installing the firmware:
1. From the printer display panel, press Maintenance.
2. Press System.
3. Press Load Upgrade. The printer will then display “Send upgrade from workstation” followed
by the printer’s IP address.
4. Open CatalystEX and click on the Printer Services tab.
5. Click on the Update Software button. CatalystEX will now connect to the printer and will
prompt you to locate the upgrade file. Navigate CatalystEX to the directory where the upgrade
file is located. The update will automatically be loaded on to the printer. After the update has
been loaded, the display will show Verifying update.
6. When verification is complete, the display will show Reboot to complete. Press Yes. The printer
will now reboot and return to Idle.
7. Press the Maintenance button and verify the updated version was installed correctly then exit
maintenance.
To Next Page
Loading...
