Stratasys uPrint - System Firmware Overview

20
System firmware overview
• Idle: If there is no part being built and no part in the build queue, the display will show that
the printer is Idle.
• Wait for Part or Start Part: If the printer is in Idle and the build queue is empty, you can set it
to wait for a part. If the printer has a part in the build queue, you can press Start Part to start
a build.
• Building: If the printer is building a part, you can choose to pause, set the lights either ON or
OFF, view the print time or material remaining and set the printer to auto power down.
• Material: From this section you can load material, unload material or replace material.
• Standby: From this section you can set the printer to Standby mode.
• Maintenance: From this section you can make changes to the System, Setup or Machine.
Figure 16 Display panel hierarchy
Idle
status
Material
Standby
Maintenance
System
Setup
Machine
• Set Network
• Test Parts
• Load Upgrade
• Lights Always On
• Select Language
• Gantry
• Head
• Tips
• Pause
• Lights Off
• Show Time
• Auto Power Down
• Load Material
• Unload Material
• Replace Material
Wait for Part
Start Part
Building
status