Stratasys uPrint - Removing the Eeproms from the Material Guides; Removing the Desiccant from the Material Spool

60
Removing the EEproms from the material guides
1. Open the model and support material carriers and remove the material guides.
2. With a small standard screwdriver, pry the two material guide halves apart. See Figure 56.
Figure 56 Pry the model material guide apart
3. Recycle the EEPROM per your local electronics recycling guidelines.
4. Recycle the material guides per your local guidelines. See Figure 55.
Removing the desiccant from the material spool
1. Remove the excess material from the material spool.
2. Use a standard screwdriver to pry the desiccant cover open. See Figure 57.
Figure 57 Removing the desiccant
3. Remove the desiccant and recycle per your local guidelines.
4. Recycle the material spool per your local guidelines.
Pry apart with a small standard screwdriver
Pry apart with a standard
screwdriver
Remove the desiccant and
recycle. Recycle the
material spool.