Workstation Requirements 3-6
4 Operating and Maintaining the Printer
Starting the Printer 4-3
Loading Model and Support Cartridges 4-5
Producing 3D Prints 4-6
Preparing the Printer 4-6
Preparing the Build Tray for Printing on Fabric (3DFashion Technology) 4-7
Removing Fabric from the Elevated Build Tray 4-17
Starting Printing 4-18
Printer Interface Color Key 4-19
Printing Indicators 4-20
Resuming Production After Printing has Stopped 4-21
Changing the Printing Material 4-24
Changing Model Materials Without Flushing 4-29
Advanced Settings 4-32
Keeping the Printer in Idle Mode 4-35
Setting the Cartridge Expiration Alert 4-36
Shutting Down the Printer 4-38
Maintaining the Printer 4-42
Routine Maintenance Schedule 4-42
Maintenance Counters 4-43
UV Lamp Check 4-45
Pattern Test 4-45
Backing up the Printer Configuration 4-48
Improving Print Quality 4-49
Cleaning the Print Heads, UV Lamp Glass, Roller and Wiper 4-49
Cleaning the Roller Waste Collector and Inspecting the Roller Scraper 4-54
Replacing the Roller Scraper 4-58
Aligning the Print Heads 4-60
Cleaning the Print-Head Splash Shield 4-66
Optimizing (Calibrating) Print Heads 4-68
Replacing Print Heads 4-76
Testing and Calibrating the UV Lamps 4-86
Calibrating the Load Cells 4-95
Flushing the Print Block Pre-Heater 4-96
Replacing the Waste-Pump Tubes 4-103
Replacing the Material Filters 4-110
Replacing the Odor Filter 4-112
Replacing the UV Lamps 4-113
Improving Color Uniformity of X-Walls 4-122
DOC-18001 Rev. N iv
To Next Page
Loading...
