Streamax MDVRs - Cable and Wire Management; System Testing After Installation Part 2

ISTM-ALL MDVR-2012_Q2_Ver 1.0
19/27
the air-conditioner. Different vehicle has different internal environment. Every vehicle should have the suitable
installation method. Here introduce the installation steps for the vehicle with air-conditioner:
（1） Drill the hole close the channel for air conditioner
（2） Pull the wire through air conditioner channel and take it out from the hotel and connect with alarm
Box
（
3
）
Fix the button with thread forming between 2 windows in the vehicle
2.9 How to Deal with the Connection for Cables and Wire
1) Cold Pressing Connection
（
1
）
There are 3 different standards for wire connector: CHS-Φ3
、
5
、
8. according to the actual demand.
（2） All the cut cables must be connected by the wire connector
（3） Please use the wire stripper (model: HS-I01/0.5~10mm) for connection.
（4） The cold pressing process is striping the cable cover (10mm~15mm), connecting all the copper wire
together, cutting off the raw edge and put them into the suitable wire connector and then pressing connect
by the wire stripper.
（5） After the compression, please wrap the cables together by ribbon.
2) Welding
（1） If the wire of video cable or complex cable is too thin to be cold pressed, please try to weld.
（2） The power cable or others cables can not be cold pressed, please try to weld too. Wire wrap connection is
not allowed.
（3） After the welding, binding the cable with the ribbon.
（
4
）
Part 2 The Whole System Testing after Installation
1 MDVR Device Testing
1.1 Inspection before Power Connection
After all the equipments are installed, please follow the steps to check before power supply for MDVR: