www.stromltd.com
STROM LIMITED 2020
32
Electric Boilers
POWERING ON THE BOILER
IMPORTANT
Before powering on the boiler for the rst time please make sure you have completed the following:
1. All aspects of the manual proceeding this section have been completed as instructed.
2. The tted thermostat or programmer is set to the off position, or where off is not possible the thermostat
is set to the lowest possible termperature.
3. Make sure that any power isolators inside the boiler are turned on, the boiler casing is secured, and the
lower ap is in the upright position.
4. The boiler can now be powered on by activating power at the breaker in the consumer unit. The boiler will
initially power on in standby mode. The power button will bring the boiler out of standby mode, but for the
time being leave the boiler in this mode so that the boiler settings can be congured.
To Next Page
Loading...
