78 Change playback to previous/next file
EXIT To end playback. Select OK to exit or Cancel to cancel the operation.
RED To display the Seek Set menu and enter the point where the start of playback
will be skipped.
All the functions listed above are also available in the Info Banner. Press OK or INFO to display it and use
t u to select the option, confirm with OK. The Info Banner contain en extra function
to manage the
sequence of the files.
8.3 Picture
Supported media formats are: JPG, BMP.
OK Open selected photo in full screen. To display the Picture Option menu. Select
Auto Play to set On/Off automatic display of the photos contained in the
folder. Select Action to set the interval mode between photos
RED GREEN YELLOW To rotate the displayed image
EXIT Stop the slideshow and return to preview mode.
9.0 NETWORK
This item allows you to setup your network connection. As described in chapter 8.3.7 there are two
different settings available: Auto and Manual. When Auto is selected, the receiver set automatically all the
parameters (not editable) and automatically connects to the network. Selecting Manual the parameters
have to be set manually, otherwise no connection will be detected.
9.1 IP Setting
Here below are listed the parameters available:
Access way: Select between Auto (default setting) and Manual.
IP Adress: Set the IP address manually.
DefaultGateway: Set the GATEWAY address manually.
NetMask: Set the Netmask address manually.
Primary DNS: Set the main DNS address manually.
Second DNS: Set an optional alternate DNS address manually.
MAC: Set the MAC address manually
9.2 Software Update
There are two different ways to update the software of this receiver: USB or OTA (Over The Air). All the
information regarding the update are reported in chapter 8.4.4 S/W Upgrade.
NOTE: A software upgrade via satellite may take some time, even up to an hour, to
complete. The unit will automatically check for, and install newer software if
available, according to the default setting.
10.0 TROUBLESHOOTING
There may be various reasons for faulty operation of the receiver. Please check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please contact
21
To Next Page
Loading...