Cleaning Instructions Continued…
Note: These steps take place AFTER case has
defrosted and power has been turned off.
23. After cleaning, rinsing and drying tub area, is
complete, place evaporator fan shroud assembly
back into case.
24. Firmly reconnect two-pronged plug into
receptacle.
25. Re-tape plug with existing electrical tape. If tape
has lost its adhesiveness, replace.
26. Replace fan cover panels. Note
: fan cover are
NOT symmetrical.
27. Place center support rail across case (slots are at
each inside end panel of case).
WEEKLY CLEANING (TO BE PERFORMED BY STORE PERSONNEL) - PAGE 4 of 4
18
28. Place support rails across case (slots are at both
front and rear of case). Optional Ice Cream Pan
Adapter Plate: Place ice cream pan adapter plate
across support rails as shown.
29. Set pans into place (in support rails).
30. Slowly lower curved glass.
> Turn crank drain valve back to the internal
evaporator pan position. If no floor drain was used,
empty bucket of it contents.
> Turn main power switch back on.
Caution! Case must run at least 1 1/2 hours
(90 minutes) to assure proper case temperatures
before returning product to case.
> Return product to the case.
CAUTION! YOU MUST PERFORM THIS CLEANING PROCEDURE EVERY 7 DAYS TO
PREVENT ICE BUILDUP AND TO KEEP CASE RUNNING AT PROPER TEMPERATURE.
23
29
28
30
24
25
26
27
Center Support Rail
Support Rails
(Typical)
Fan Cover Panel
Ice Cream
Pan Adapter
Plate
(Optional)
To Next Page
Loading...
