Structural Concepts ENCORE Series - Start-Up and Operation

Merchandiser Start-Up
 Self-Contained: Main Power switch is located at
case rear, lower left. See illustration at lower
right and lower left.
 Remote Units: Case is hard-wired. When power
is supplied, case will power-up.
 Lights: Turn on the lights. Whether Remote or
Self-Contained, light switch is located on inside of
case at top left, from case rear. See illustration
at top right.
 Light Warm-up: All lights should come on at the
same time. First time lighting may require a short
warm up period for the bulbs. Slightly dim or a
flickering of new bulbs is normal.
 Merchandising: Please allow unit to run empty
for at least 1 1/2 hrs (90 minutes) before
merchandising.
Raise the Curved Glass
 To raise the curved glass, grasp the lift handle
extrusion on the bottom edge of the door and lift
up. See illustration below-right.
 Caution: Carefully return curved glass to original
position.
Removing (Optional) Rear Glass Doors
 Move rear doors toward the case center.
 Individually lift each door up toward top of case
and pivot bottom of the door out.
 Caution: Gently set doors down to avoid marring,
scratching or breakage.
7
START-UP AND OPERATION
Main
Power
Switch
View of Curved
Glass being
raised
Main Power
Switch
Temperature Controller Location:
G24F: At Left Side of Case Rear
(as shown above)
G12F
: At Right Side of Case Rear
View of
Rear Door
being lifted
up,
pivoted out
and away
from
case
Curved Glass
Lift Handle
Temp.
Controller
(see Temp.
Controller
Section)