Structural Concepts ENCORE Series - Preventive Maintenance (to be Performed by Trained Service Providers Only)

21
PREVENTIVE MAINTENANCE (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS)
PREVENTIVE
MAINTENANCE
FREQUENCY INSTRUCTIONS
Case Exterior Monthly Condensing Coil: Disconnect power from case before cleaning.
 Remove rear grille (by removing 4 screws).
 Slide/roll out refrigeration assembly. Note
: At initial slide-out, it may be
necessary to remove two (2) compressor pan shipment screws for
refrigeration assembly to slide out.
 Use air pressure or industrial strength vacuum; clean dust and dirt that may
collect on the condenser coil. See illustration below.
 Caution! Coil fins are sharp. Handle with care!
 Slide/roll condensing unit assembly back under case.
 Replace rear grille to case (4 screws).
 See illustration below.
Quarterly Optional Clean Sweep™ Condensing Coil: Disconnect power from case
before cleaning Clean Sweep™ Condenser Coil!
 Remove rear grille (by removing 4 screws).
 Slide/Roll out condensing unit assembly.
 Remove the four (4) screws holding the Clean Sweep™ rails intact.
 Remove the Clean Sweep™ rail.
 Wash rails’ brushes in hot water and mild soap solution.
 If brushes are worn, they must be replaced. Call Technical Service
Department to replace. Toll-Free number is listed at end of manual.
 Clean condensing coil: Use air pressure or industrial strength vacuum;
clean the dust and dirt that may collect on the Condenser Coil.
 Caution! Coil fins are sharp. Handle with care!
 Reattach Clean Sweep™ rail to condensing unit (4 screws).
 Slide/roll condensing unit assembly back under case.
 Replace rear grille to case (4 screws).
 See photos below.
(4) Screws
--- Above photos are taken after rear grille has been removed from case ---
Co
n
de
n
s
i
ng
Coil
Brushes
Rail