Struers Minitom - Checking the Contents of Packing; Placing Minitom

Minitom
Instruction Manual
11
In the packing box you should find the following parts:
1
Minitom (precision cut-off machine)
1
Arm with universal specimen holder
1
Splash Guard
1
Grid plate for collecting the specimen
1
Coolant tank with grid plate
1
Set of flanges, 42 mm dia.
1
Set of flanges, 65 mm dia.
2
M5x40 mm screws for large specimens
1
Allen key, 2.5 mm
2
Allen key, 4 mm
2
Mains cables
1
Instruction Manual set
NOTE
Store the packing box and foam packaging for future use.
Failure to use the original packaging and fittings could cause
severe damage to the machine and will void the warranty.
 Place Minitom on a safe and stable support table or work bench.
− Check that the machine rests securely with all 4 rubber feet
on the table.
− The table should have an adequate working height.
Recommended height 80-90cm.
 Place Minitom close to connections for mains power.
NOTE
Ensure that the work station has adequate, ambient lighting (300
lumen). Avoid direct glare (dazzling light sources within the
operator's line of vision) and reflected glare (reflections of light
sources).
Checking the Contents of
Packing
Placing Minitom