Stryker Isolibrium 2971 User Manual

EENN
www.stryker.com 2971-109-0 01 REV B 1-63
Product labels
All the product labels listed (Figure 1-34 on page 1-63, Figure 1-35 on page 1-64, Figure 1-36 on page 1-65, and Figure
1-37 on page 1-65) are attached to the Isolibrium support surface.
Note: These labels (Figure 1-34 on page 1-63) are required for standards in the United States and Canada and are in
English and French Canadian. They are not required to be translated into any other language.
1
P/N 2971-021-902 REV D.0
UNDER PENALTY OF LAW
THIS TAG NOT TO BE REMOVED
EXCEPT BY THE CONSUMER
ALL NEW MATERIAL
Consisting of
FOAM........................………................56%
Certification is made by the manufacturer that the
ma teria ls in this a rticle a re de s cribe d in
accordance with law.
STRYKER MEDICAL
3800 E. Centre Avenue
Portage, MI 49002-5826 USA
REG. NO. UT-3215 (MI)
Finished Size: 84 in x 35 in x 8 in
(213.4 cm x 88.9 cm x 20.3 cm)
MADE IN U.S.
A
.
Model: 2971-ISOLIBRIUM
Prototype ID: 2390428
This mattress meets the requirements of 16
CFR Part 1633 (federal Flammability (open
flame) standard for mattress sets) when used
without a foundation.
THIS MATTRESS IS
INTENDED TO BE USED
WITHOUT A FOUNDATION
UT-3215
Net Weight of Filling Mat’l: 50 lb, 0 oz
DRY POLYMER GEL...........................26%
POLYURETHANE FILM...…................18%
Not to be removed until delivered to the
consumer .
Ne pas enlever avant la livraison au
consommateur .
This article contains
NEW MATERIAL ONLY
Cet article contient des
MATÉRIAUX NEUFS
SEULEMENT
This label is affixed in compliance with Provincial Law.
Cette étiquette est apposée conformément au
règlement provincial.
Made by
Reg. No.
Content
Aluminum Metal
Dry Polymer Gel
Foam
Polyurethane Film
Contenu
Aluminium Métallique
Gel Polymè re Sec
Mousse
Film De Polyur éthane
Fabricad o por
N.º de re gistro
Figure 1-34: Law label

Stryker Isolibrium 2971 Specifications

General

Brand	Stryker
Model	Isolibrium 2971
Category	Medical Equipment
Language	English