Stryker X8000 Service Manual (English)

Other manuals for Stryker X8000

Questions and Answers:

michaellewisJul 28, 2025

How to fix Stryker X8000 Medical Equipment with no light output?

L
laurie33Jul 28, 2025
If your Stryker Medical Equipment isn't providing any light output, first, make sure the AC power cord is correctly plugged into both the hospital-grade outlet and the back of the console. Next, check that the power switch on the front is on and illuminated. Also, verify all fuses are working correctly. Ensure the bulb is correctly positioned in its housing, turned to the left, and that the bulb itself is in good working order, replacing it if needed. Confirm the light cable is properly connected to the port and that the bulb access door is fully closed. Finally, check that vents are not blocked. If none of these steps work or the safety shutoff has been activated, the X8000 needs to be returned for service.

fischeramandaAug 11, 2025

What to do if Stryker X8000 Medical Equipment has too much or too little light output?

T
Tim NovakAug 11, 2025
If you're experiencing too much or too little light output with your Stryker Medical Equipment, first ensure the light cable is properly connected to the cable port. Check the bulb's remaining life, as it's warranted for 500 hours. Make sure the X8000 is in Run mode by pressing the Mode button if needed. If using an ESST cable, confirm it's correctly attached to the scope with an ESST adapter. Adjust brightness using the up/down buttons. Inspect the fiberoptic cable for black spots by holding it to a light source; if spots are present, the cable may need replacement. Lastly, ensure the light cable size is appropriate for your application.