To Next PageTo Next PageWhat to do if Stuart Turner Mainsboost Plus shows Hnt high temp cut out?
If your Stuart Turner Water System displays an 'Hnt high temp cut out' message, it means the pump head is overheating because the head temperature has exceeded the set Hnt value. To resolve this, allow the pump to cool down. Also, check the pump inlet check valve and bypass for any debris and clear it.
What to do if Stuart Turner Mainsboost Plus shows Hpr Hi pressure cut out?
If your Stuart Turner Water System shows an 'Hpr Hi pressure cut out', investigate the cause. Then, turn the power off and on to reset the system, or allow it to self-reset.
General| Brand | Stuart Turner |
|---|---|
| Model | Mainsboost Plus |
| Category | Water System |
| Language | English |
Details the three key assemblies and intended use of the Mainsboost Plus system.
Covers parameter limits, child safety, and warranty conditions for the unit.
Advises on storing the product in a dry, frost, and vibration-free location.
Lists all parts included in the vertical Mainsboost Plus package.
Lists all parts included in the horizontal Mainsboost Plus package.
Introduces the system, its patent, and registered trade names.
Explains the operational principle, including the 'green energy' bypass feature.
Covers commissioning, water temperature limits, and pipework requirements.
Details plumbing/electrical regulations and Mainsboost vessel safety warnings.
Covers access, protection from elements, ventilation, and water retention.
Details static inlet pressure, mains pressure, ambient temp, and pipework sizing.
Illustrates suction and discharge connections for vertical and horizontal units.
Defines system configuration terms 'Upstream' and 'Downstream' with diagrams.
Illustrates typical configuration for a single house.
Shows configuration for multi-apartment buildings with individual units.
Describes using multiple vessels in parallel for high demand scenarios.
Advises on the correct placement of a water softener within the system.
Covers unpacking, positioning, and connecting the vessel connector and isolating valve.
Details how to attach the pump assembly to the Mainsboost vessel.
Explains assembly of the pump manifold and fitting the pressure relief valve.
Guides positioning for the upstream kit and details its components and pipe length requirements.
Details connecting the pressure relief valve outlet to a tundish.
Shows the final assembly of the vertical Mainsboost Plus unit.
Illustrates the final assembly of the horizontal Mainsboost Plus unit.
Mentions the availability of a sound attenuation cover for noise-sensitive areas.
Covers compliance with regulations, RCD use, and power isolation for safety.
Explains earthing, connections, and wire color conventions for the unit.
Provides a detailed wiring diagram for the Mainsboost Plus system components.
Specifies the fuse rating and guidelines for replacing the supply cord.
Guides on checking the system and vessel pre-charge air pressure.
Details how to measure and record static mains water pressure.
Lists the default settings for the control module's operation.
Explains the steps to change pump parameters via the control module interface.
Details the process of filling the system with water and purging air.
Explains how to operate the bypass valve based on incoming flow rate.
Covers general, performance, pump, and electrical technical data in tables.
Provides detailed physical dimensions and weights for vertical and horizontal models.
States the maximum equivalent continuous A-weighted sound pressure level.
Discusses optional sound attenuation covers for reducing noise levels.
Explains the alarm buzzer, remote option, and lists common fault codes.
Details the guarantee period, coverage, exclusions, and how to make a claim.
