FORESTER (NA) A8050BE–A (ENG.)
2-14
n To arm the system using power door locking switches
HB2024CC
1. Close all windows and moonroofs (if so equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate) but leave only the driver’s door
or the front passenger’s door open.
6. Push the power door locking switch forward (“LOCK” side) to set
the door locks.
7. Close the door. The horn will sound one time, the parking lights will
flash one time and the indicator light will start flashing slowly (approxi-
mately once every two seconds) to inform you that the system has
armed.
NOTE
The system can be armed even if the engine hood, the windows
and/or moonroofs are opened. Always make sure that they are
fully closed before arming the system.
B Disarming the system
Briefly press the “UNLOCK/DISARM” button (for less than two
seconds) on the remote transmitter. The driver’s door will unlock, the
horn will sound two times, the parking lights will flash two times and
the indicator light will go off.
To Next Page
Loading...
