Why does control activate even though there is no vehicle in front detected by Subaru Automobile Accessories?
Depending on road conditions, vehicles in neighboring lanes may be detected as a vehicle directly in front. Also, when driving on or near a curve, braking control may activate in response to guard rails, the angle of the steering wheel, or roadside structures.
Why is cruise control canceled automatically in my Subaru Automobile Accessories?
Cruise control may be canceled automatically if the EyeSight system has temporarily stopped while the Adaptive Cruise Control function was in use.
Why is a vehicle not detected, detection is delayed, or detection is lost quickly by Subaru EyeSight Automobile Accessories?
Detection of stopped vehicles, vehicles moving slowly relative to your vehicle, and vehicles moving extremely slowly may be difficult. If the windshield is dirty or fogged, clean it to improve detection. Also, the maximum detection distance of EyeSight’s stereo camera is approximately 360 ft (110 m), and detection is not possible if the vehicle is farther away. The detection range is limited on curves, roads with repeated uphill and downhill grades, or banked roads. Detection may be delayed after the vehicle in front has changed, or when water, snow, or other substances are kicked up by the vehicle in front.
Why does the Lead Vehicle Start Alert activate even though there is no vehicle in front for Subaru Automobile Accessories?
The Lead Vehicle Start Alert may issue a warning in response to objects other than a vehicle that appear in front of your vehicle, depending on surrounding objects, traffic environment, and weather conditions.
Why EyeSight does not restart after a temporary stop in Subaru Automobile Accessories?
EyeSight may remain temporarily stopped if you are parking in extremely hot or cold conditions until the temperature returns to normal. Also, it may not restart if you are driving in the rain with poorly performing wipers or an oily film on the windshield. Consider replacing the wipers or cleaning the windshield. EyeSight may also temporarily stop operating in poor weather conditions with heavy rain, snow, fog, or dust, or if your vehicle is subject to direct sunlight or bright headlights.
What to do if a noise occurs when automatic braking control activates in Subaru EyeSight?
The noise you hear is the normal sound of the automatic braking control operating. The system has mechanical components that may make audible sounds during automatic braking. This does not indicate a malfunction.
Why is my Subaru EyeSight Automobile Accessories Lane Keep Assist unexpectedly canceled?
Lane Keep Assist may be temporarily canceled if the system cannot detect steering operation, which can happen if you take your hands off the steering wheel or only lightly touch it. Also, Lane Keep Assist does not operate while turning a tight corner.
What to do if Adaptive Cruise Control cannot be set in Subaru EyeSight?
First, ensure that you have pressed the (CRUISE) switch; the (Adaptive Cruise Control indicator) will not appear if you haven't. Next, check if EyeSight operation is temporarily stopped, indicated by the (EyeSight temporary stop indicator). If so, resolve the cause of the stop and then try setting Adaptive Cruise Control again. Finally, confirm that the (READY indicator) is displayed, as Adaptive Cruise Control cannot be set without it.
General| Type | Driver Assist Technology |
|---|---|
| Camera System | Stereo Camera |
| Additional Functions | Adaptive Cruise Control, Lane Keep Assist |
| Detection Range | Up to 110 meters |
| System Activation | Automatic upon vehicle start |
| Availability | Standard or Optional on most Subaru models |
To Next Page
