EasyManua.ls Logo

Subaru outback 2017 - Front Fog Light Switch (if Equipped); Steering Responsive Fog Lights System (Models with Eyesight System)

Subaru outback 2017
610 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruments and controls/Front fog light switch
Front fog light switch
(if equipped)
1) Headlight switch
2) Fog light switch
To turn on the front fog lights:
Turn the fog light switch to the
position while the headlights are in either
of the following conditions.
. while the headlight switch is in the
position with the low beam mode selected
. while the headlight switch is in the
AUTO position and the low beam head-
lights turn on automatically
To turn off the front fog lights:
Turn the fog light switch back down to the
position.
Indicator light
The indicator light located on the combi-
nation meter will illuminate when the front
fog lights are on.
& Steering responsive fog
lights system (models with
EyeSight system)
The steering responsive fog lights system
automatically turns the front fog light on
and off based on the steering angle and
vehicle speed when entering a curve or
driving on curved roads. The system is
intended to help pre vent accidents by
enabling better visibility of curves ahead
and early recognition of any disabled
vehicles or other obstacles.
The front fog light on the inside of a curve
will turn on if all of the following conditions
are met.
. The low beam headlights are on
. The fog light switch is in the
position
. The low beam mode is selected (the
turn signal lever is in the center position)
. The select lever is in the D position or
the manual mode is selected
. The steering response fog lights sys-
tem has not been deactivated
. The operating conditions such as the
steering angle and vehicle speed are met
The front fog lights on both sides will turn
on as usual if all of the following conditions
are met.
. The low beam headlights are on
. The fog light switch is in the
position
. The low beam mode is selected (the
turn signal lever is in the center position)
3-56

Table of Contents

Related product manuals