nation meter will appear.
2. Depress the accelerator pedal until the
vehicle reaches the desired speed.
3. Press the “RES/SET” switch to the
“SET” side and release it. Then release
the accelerator pedal.
Cruise control set indicator
1) When se tting the displayed unit as
“MPH”.
2) When se tting the displayed unit as
“km/h”.
At this time, the cruise control set indicator
appears in the combination meter. The set
speed will be shown on the combination
meter. You can change the displayed unit
by operating the multi information display.
For details, refer to “Units” F3-44.
The vehicle will maintain the desired
speed.
Vehicle speed can be temporarily in-
creased while driving wi th the cruise
control activated. Sim ply depress the
accelerator pedal to accelerate the vehi-
cle. When the accelerator pedal is re-
leased, the vehicle will return to and
maintain the previous cruising speed.
& To temporarily cancel the
cruise control
The cruise control can be temporarily
canceled in the following ways.
. Press the “CANCEL” button.
. Press the X-mode switch to activate
the X-mode (models with X-mode).
. Depress the brake pedal.
. Depress the clutch pedal (MT models).
WARNING
For CVT models, do not place the
select lever in the “N” position while
driving. If the select lever is shifted
into the “N” position, cruise control
can be canceled but the engine
Starting and operating/Cruise control
– CONTINUED –
7-51
To Next Page
Loading...
