Suburban Dynaline 3 User Manual

Suburban Dynaline 3 A&E Manual 12/2016 Rev.1
15
X" REPRESENTS EITHER THE
DIMENSION REQUIRED TO FLUSH
SLEEVE TO FINISHED TRIM OR
MOLDING, OR THE DISTANCE
SLEEVE PROJECTS INTO ROOM
BEYOND FINISHED INTERIOR
WALL.
NOTE: X" CAN BE 0"
IF SLEEVE IS FLUSH
WITH FINISHED
INTERIOR WALL.
SURFACE OF FINISHED INTERIOR WALL
CABINET FRONT
SLOPE DOWN TO THE OUTSIDE
MIN. (PROJECTION BEYOND EXTERIOR WALL)
MOUNTING HOLES AND SCREWS
(BY INSTALLER.)
DO NOT PUT HOLES THROUGH
WALL SLEEVE BOTTOM!
REAR GRILLE
CAULK AROUND WALL SLEEVE
SURFACE OF FINISHED EXTERIOR WALL
3 (MIN.)
2
1"
Y"
X"
Y" = 14 - ( X" + )
3"
4
1"
4
1"
4
1"
4
SURFACE OF FINISHED
FLOOR OR TOP OF CARPET
SLOPE DOWN TO THE OUTSIDE
SURFACE OF FINISHED
FLOOR OR TOP OF CARPET
MIN. (PROJECTION BEYOND WALL)
WALL SLEEVE ANGLES & SCREWS
(BY INSTALLER.)
DO NOT PUT HOLES THROUGH OR DRIVE
SCREWS INTO WALL SLEEVE BOTTOM!
CAULK AROUND WALL SLEEVE
WINDOW OR WALL
CABINET FRONT
WALL SLEEVE
(MAX.) LONG SCREWS FOR SECURING
ANGLES TO TOP & SIDES OF SLEEVE.
2 (MIN.) SUPPORTS
(BY INSTALLER)
REAR GRILLE
1"
2
3 (MIN.)
1"
2
1"
4
1"
4
Figure 10
Figure 11
WALL INSTALLATION
FRONT GAS HOOK-UP
WINDOW, CURTAIN WALL, OR
WALL PANEL INSTALLATION

Suburban Dynaline 3 Specifications

General

Brand	Suburban
Model	Dynaline 3
Category	Heating System
Language	English