SUEX 7Seven - Using the DPV; Preliminary Operations; DPV Start Procedure

Pag. 8/41
3. USING THE DPV
The DPV manufactured by SUEX s.r.l. has been designed and built for towing a diver underwater. Any alterations
that may substantially modify its intended purpose are forbidden.
Custom Suex engineering exclusions apply.
The DPV has been designed, sized and built for the sole purpose described above. Any other
use or operation that does not comply with the instructions contained in this manual, may
damage the DPV. This would prevent the conditions for which it has been designed and built
from being achieved, and may compromise its technical and safety characteristics. The
manufacturer shall not be liable for damage to persons and/or objects deriving from
inappropriate use of the vehicle.
4. PACKAGE CONTENT
Make sure the following parts are in the box:
 A DPV
 A battery
 A battery charger
 An accessories kit
5. PRELIMINARY OPERATIONS
The following operations can be carried out after a complete and careful reading of this instruction manual
by trained personnel:
 Verify the DPV is not damaged and fully operational
 Verify that the DPV is hermetically closed
 Verify that the battery is fully charged and connected to the motor
 Verify that the towing system is fully operational
5.1. DPV START
 Once the preliminary operations are carried out
 Submerge the DPV
 Verify that the propeller is free of any obstruction, debris
 Turn the main switch in ON position (6) (see fig.2).
 Hold the DPV’s handles (1) (see fig.1).
 Pull the trigger(2), The DPV starts to run
 Pull off the trigger and the DPV stops
 Start the dive