Section 2
DESCRIPTION
21
Table 2 - Possible Performance of Active Diagnostic Codes
Flash
Code
Description of Code
CID-FMI
Code
SPN-FMI
Code
Engine
Misfires
Low
Power
Reduced
Engine
Speed
Engine
Shutdown
12 Incorrect Crank-without-inject inputs 266-02 266-02
13
Fuel Temperature open/short to +batt 174-03 174-03
Fuel Temperature short to ground 174-04 174-04
21
5 Volt Sensor DC Power Supply short to +batt 262-03 620-03
5 Volt Sensor DC Power Suppy short to ground 262-04 620-04
Digital Sensor Supply short to +batt 263-03 678-03
Digital Sensor Supply short to ground 263-04 678-04
24
Engine Oil Pressure open/short to +batt 100-03 100-03
Engine Oil Pressure open/short to ground 100-04 100-04
25
Turbo Outlet Pressure above normal 273-00 102-00 X
Turbo Outlet Pressure open/short to +batt 273-03 102-03 X
Turbo Outlet Pressure short to ground 273-04 102-04 X
26
Atmospheric Pressure open/short to +batt 274-03 108-03
Atmospheric Pressure short to ground 274-04 108-04
27
Engine Coolant Temperature open/short to +batt 110-03 110-03 X X X
Engine Coolant Temperature short to ground 110-04 110-04 X X X
28 Throttle Position calibration required 91-13 91-03 X X
32 Throttle Position signal abnormal 91-08 91-08 X X
34
Speed/Timing Sensor Loss of Signal 320-02 190-02 X
X (I)
Speed/Timing Sensor mechanical failure 320-11 190-11 X
X (I)
Loss of Secondary Engine Speed signal 342-02 723-02 X
X (I)
Secondary Engine Speed Sensor mechanical failure 342-11 723-11 X
X (I)
35
Engine Overspeed Shutdown 004 0190-16
Engine Overspeed Warning 190 0190-00
37
Fuel Pressure open/short to +batt 94-03 94-03
Fuel Pressure short to ground 94-04 94-04
Engine Oil Temperature open/short to +batt 175-03 175-03
Engine Oil Temperature short to ground 175-04 175-04
38
Intake Manifold Air Temp open/short to +batt 172-03 172-03 X X X
Intake Manifold Air Temp short to ground 172-04 172-04 X X X
42 Engine Timing calbiration required 261-13 228-13 X X X X
46
Low Engine Oil Pressure Warning 100 0100-17
Low Engine Oil Pressure Derate 039 0100-18
Low Engine Oil Pressure Shutdown 040 0100-01
X (I) X (I) X (I)
51 System voltage intermittent/erratic 168-02 168-02 X X X
53 Electronic Control Module Error 254-12 no code X X X X
56
Personality Module mismatch 253-02 234-02
X (II)
Check Prgrammable Paramters 268-02 111-02 X X
(I) The engine will shut down if both speed/timing sensors are lost.
(II) Fuel injection will not occur and the engine will not start.
NOTE: Sullair engines are programmed to shut down.
CID = Component Identifier SPN = Suspect Paramater Number FMI = Failure Mode Identifier
Continued...
To Next Page
Loading...
