Sullair 1350XH - Aftercooled

Section 7
ILLUSTRATIONS AND PARTS
87
7.14B DISCHARGE SYSTEM - 900XH-1150XH AFTERCOOLED
key part
number description number quantity
1 hose, medium pressure .25 x 86” w/37 swvls 02250054-261 1
2 sub assembly, vlv assy 2.5 npt x 2.5 4bsf disch (I) 02250081-044 1
3 hose, medium pressure 5/16 x 54” lg 37deg st 02250083-838 1
4 valve, ball 2” fnpt w/o drain 02250086-337 3
5 hose, disch 2.5” st stl 900xh 02250092-744 1
6 flange, kit sae splt 2” - viton 02250099-415 5
7 flange, kit sae splt 2.5” - viton 02250099-416 1
8 sub assembly, water trap assy 900xh ac (II) 02250131-654 1
9 adapter, 2” tube assy w/4-bolt flg 02250131-977 2
10 sub assembly, air control manifold 900xh tier ii (III) 02250132-421 1
11 sub assembly, speed control tier ii (IV) 02250132-481 1
12 pipe, assembly trap/svr vlv 900xh ac 02250133-469 1
13 support, pipe cs 900xh 02250133-724 1
14 sub assembly, inlet valve 8” 1150/350 (V) 02250134-299 1
15 support, discharge pipe 1150xha w/o canopy 02250139-929 1
16 sub assembly, receiver cat 1150xha w/o canopy (VI) 02250139-932 1
17 pipe, assembly rec tank/aftclr 900xhh ac 02250142-706 1
A1 Refer to Section 7.17 Sub-assembly - High Pressure Filter / Check Valve / Orifice for
additional information.
(I) For maintenance on valve sub-assembly no. 02250081-044, order repair kit no. 606208-001, and
replacement gasket no. 046053 (refer to key number 21 of this Section).
(II) For additional information pertaining to water trap sub-assembly no. 02250131-654, consult Section
7.16, Water Separator Trap - Aftercooled Only.
(III) For additional information pertaining to air control manifold sub-assembly no. 02250132-421, consult
Section 7.11, Air Control Manifold Assembly - All Models.
(IV) For additional information pertaining to speed control sub-assembly no. 02250132-481, consult
Section 7.10, Speed Control Cylinder and Parts - All Models.
(V) For additional information pertaining to inlet valve sub-assembly no. 02250134-299, consult Section
7.12B, Inlet Valve and Parts (8”) - 1150XH-1350XH for external parts, and Section 7.13B, Inlet Valve
and Parts - 8” - 1150XH-1350XH for assembly.
(VI) For additional information pertaining to receiver sub-assembly no. 02250139-932, consult Section
7.15B, Receiver and Parts - 1350XH Standard and Aftercooled, and Section 7.17, Sub-assembly -
High Pressure Filter / Check Valve / Orifice.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE THE SERIAL NUMBER OF COMPRESSOR
Continued on page 89