Section 3
SPECIFICATIONS
21
LUBRICATION GUIDE --- COMPRESSOR
FLUID TYPE
CHANGE PERIOD, HOURS
AMBIENT TEMPERATURE
RANGE
_
F(
_
C)
Sullair AWF 1200 ---20 to 120 (---29 to 49)
D --- A Torque Fluid
SAE10W SE, SF, SG, CD
MIL---L---2104E 10W
300
300
10 to 110 (---12 to 43)
0 to 100 (---18 to 38)
0 to 100 (---18 to 38)
300
(I)
(I)
Sullair part numbers for Sullair AWF are 250030---757 (5 gallons/20 liters) and 250030---758 (55 gallon drum/208 liters).
APPLICATION GUIDE
Sullair Air Compressors are supplied with Sullair
AWF which is heavy duty multi---viscosity, all---
weather fluid. Sullair AWF also allows an extended
change interval. Detergent motor oils (SAE 10W
Class SE,SF, SG or CD) can also be used. Any of
these oils are suitable under conditions where se-
vere oil oxidations can occur.
Water must be drained from the receiver periodical-
ly. In high ambient temperature and high humidity
conditions, condensed moisture may emulsify with
theoilforminga
“
milky”color.SAE10Wisespecially
pronetothis condition. The fluidshould bechanged
if this condition develops.
DO NOT
mix types of fluids. Combinations of differ-
ent fluids may lead to operational problems such as
foaming, filter plugging, orifice or line plugging.
When ambient conditions exceed those noted or if
conditions warrant use of other extended life lubri-
cants, contact Sullair for recommendations.
Sullair encourages the user to participate in a fluid
analysis program. This could result ina fluid change
interval differing fromthat stated in the manual. Sul-
lair Corporation offers a fluid analysis program for
Sullair AWF. Contact your local Sullair representa-
tive for details.
D---A Lubricant
r
Company Inc. offers an analysis
program forusers ofD---Aproducts and Sullair AWF.
Contact your D---A lubricant supplier or Sullair re p-
resentative for details.
LUBRICATION GUIDE --- ENGINE
Forengine oil specifications, refertothe Engine Op-
erator’s Manual.
To Next Page
Loading...
