Section 7
ILLUSTRATIONS AND PARTS LIST
49
7.3B ENGINE, COMPRESSOR & PARTS -- 260 CATERPILLAR
key part
number description number quantity
1 key, .375 x .312 x 1.80 class #2 02250060---568 1
2 spacer, brake lever 250p 02250064---594 1
3 valve, air inlet 2 1/2” black (I) 02250088---348 1
4 elbow, 90 3/8”tube x 1/4”npt m 02250099---626 1
5 s pring, extension 3.0lg 4.52lb/in .313od 02250124---065 1
6 washer, snubbing vibration mount 02250125---471 4
7 mount, vibration isolator 185 02250125---472 4
8 hose, parcrimp 3/4 x 26 02250126---680 1
9 tee, male branch 3/8”tube x 1/4”npt m 02250136---998 1
10 support, compressor 12s 260dpq 02250146---142 1
11 support, engine l&r 185h---260 pe 02250146---146 2
12 spacer, fan 1.5” lg 185h---260 pe 02250146---479 1
13 fan, 18” blower 185h---260 pe 02250146---549 1
14 hose, 1---1/2---18” 185h---260dpq 02250146---978 1
15 rod, speed ctl 185dpq jd 02250148---086 1
16 support, speed cyl 185h---260 ca/pe 02250149---240 1
17 cover, eng pto 185h---260 cat 02250150---197 1
18 gasket, eng pto 185h---260 cat 02250150---198 1
19 orifice, .062” x .25m x .25m nptf 027443 1
20 clamp, hose 13/16” to 1---1/2” 040513 1
21 compr model, 12series unit (II) 1
22 joint, ball female 1/4” l.h. 250011---578 1
23 joint, ball female 1/4” r.h. 250011---597 1
24 elbow, 1/4” tube x 1/4” npt 250018---430 1
25 spacer, air conn vlv 250q 250022---950 1
26 cylinder, speed 3/4 x 1 stroke 250024---272 1
27 housing, adapter (250034---402c) 250034---403 1
(Continued on page 51)
NOTE: For in depth coverage of the engine, consult the Engine Operator’s Manual. For maintenance on
Caterpillar engine oil filter, order replacement filter no. 02250150---119. For maintenance on Caterpillar
engine fuel filter, order replacment filter no. 02250150---120.
(I) See Section 7.5 for breakd ow n of the inlet filter. For maintenance on air inlet valve no. 02250088---348,
order repair kit no. 250019---451, or s p ring replacement kit no. 250029---315.
(II) There is an exchange program w h ereby a remanufactured compressor unit can be obtained from Sulla ir
distributors or the factory at less cost than the owner could repair the unit. For information regarding the
unit exchange program, contact your nearest Sullair representative or the Sullair Corporation.
The shaft seal is not considered part of the compressor unit in regard to t he two year warranty. The
normal Sullair parts warranty applies. For shaft seal repairs consult factory.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
