Section 6
MAINTENANCE
21
* Repair Kit P/N 001100
Figure 6---2 Main Filter (P/N 044286)
should never require changing unless damage oc-
curs. For installation of the filter seal number
001100, follow the procedure explained below.
DISASSEMBLY
1. Disassemble the filter by removing the four (4)
capscrews and separate the filter head and ele-
ment (as an assembly) from the housing.
2. Remove the hex nut, located inside the element,
from the valve stem.
3. At this time, pull the element, spring, spring seat
and spring retainer from the valve stem.
4. Remove the inner seals of the element and t he
filter head seal and discard.
5. Clean all parts of the filter thoroughly including
the housing.
REASSEMBLY
1. Lubricate the new inner seals and install in the
ends of the clean element.
2. Place the filter element, spring seat, s pring and
spring retainer over the valve stem and secure
with hex nut.
3. Lubricate and install the new filter seal.
4. Install the filter head and element (as an assem-
bly) in the filter housing. The element is to s lide
over the housing sleeve w hen properly installed.
5. Secure the filter head w ith the four (4) caps-
crews.
AIR FILTER M AINTENANCE
Refer t o Figure 6 --- 3. Air filter maintenance should
be performed w hen the maintenance gauge shows
a red signal. The air filter supplied with the com-
pressor has a cleanable---type element. Below you
will find procedures on how to replace and how to
cleantheairfilterelement.
AIRFILTERELEMENTREPLACEMENT
1. Clean the exterior of the air filter housing.
2. Remove the air filter cover assembly by loosen-
ing the wingnut securing it.
3. Remove the internal cover plate.
4. Remove element a nd clean the interior of the
housing using a damp cloth. DO NOT blow dirt
out with compressed air.
* R eplacement element P/N 042643
Figure 6 ---3 Air Filter (P/N 012516 --- Base)
(P/N 013448 --- Housing)
To Next Page
Loading...