Sullair 375H - Page 44

300HH, 375, 375H, 375HH, 425 AND 425H USER MANUAL R00 SECTION 2
42
5. Use Defaults—To select USE DEFAULTS
use the arrow keys to scroll to and highlight
USE DEFAULTS in the menu display.
6. Press the ENTER key to activate the USE
DEFAULTS function.
7. The display parameters are reset to the fac-
tory defaults, then the display will return to
the SETUP 1- UP DISPLAY menu.
8. Custom Setup – To perform a custom setup
of the SETUP 1-UP DISPLAY, use the arrow
buttons to scroll and highlight CUSTOM
SETUP on the display.
9. Press the ENTER key to display a list of
engine parameters.
10. Use the arrow keys to scroll and highlight a
selected parameter (parameter with a num-
ber to the right of it).
11. Press the ENTER key to deselect the
selected parameter, removing it from the list
PV101 SU_0000542
USE DEFAULTS
CUSTOM SETUP
AUTOMATIC SCAN OFF
Select Defaults
Figure 2-64
PV101 SU_0000543
USE DEFAULTS
CUSTOM SETUP
AUTOMATIC SCAN OFF
Defaults Selected
Figure 2-65
PV101 SU_0000544
RESTORED TO
DEFAULTS
Restored to Defaults
Figure 2-66
PV101 SU_0000545
USE DEFAULTS
CUSTOM SETUP
AUTOMATIC SCAN OFF
Selected Custom Setup
Figure 2-67
PV101 SU_0000546
USE DEFAULTS
CUSTOM SETUP
AUTOMATIC SCAN OFF
Engine Parameters
Figure 2-68
Select Parameters
PV101 SU_0000547
ACCELERATOR PEDAL POSITION
PERCENT LOAD AT CURRENT RPM
ACTUAL ENGINE TORQUE
ENGINE SPEED
TOTAL ENGINE HOURS
TOTAL FUEL USED
ENGINE COOLANT TEMPERATURE
FUEL TEMPERATURE
ENGINE OIL PRESSURE
This number indicates the order of
display for the parameters and
that the parameter is selected for
the display.
1
5
1
6
2
3
Figure 2-69