EasyManua.ls Logo

Sullair LS-10 25HP - Procedure for Ordering Parts; Recommended Spare Parts List

Sullair LS-10 25HP
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 8
ILLUSTRATIONS AND PARTS LIST
45
8.1 PROCEDURE FOR ORDERING PARTS
Parts should be ordered from the nearest Sullair Representative or the Representative from whom the com-
pressor was purchased. If for any reason parts cannot be obtained in t his manner, contact the factory directly
at the addresses, phone or fax numbers listed below.
When ordering parts always indicate the Serial Number of the compressor. This can be obtained from the Bill
of Lading for the compressor or from the Serial Number Plate located on the compressor.
SULLAIR CORPORATION
Subsidiary of Sundstrand Corporation
3700 East Michigan Boulevard
Michigan City, Indiana 46360 U.S.A.
Telephone: 1-- 219-- 879-- 5451
Fa x: (219) 874--1273
Fa x: (219) 874-- 1835 (Parts)
Fa x: (219) 874--1288 (Service)
SULLAIR ASIA, LTD.
Sullair Road, No. 1
Chiwan, Shekou
Shenzhen, Guangdong PRV.
PRC POST CODE 518068
Telephone: 755-- 6851686
Fa x: 755-- 6853473
SULLAIR EUROPE, S.A .
Zone Des Granges BP 82
42602 Montbrison Cedex, France
Telephone: 33-- 477968470
Fa x: 33-- 477968499
8.2 RECOMMENDED SPARE PARTS LIST
DESCRIPTION KIT NUMBER QTY
element, compressor fluid filter 02250096---783 250025--525 1
element, heavy duty air filter 02250107---327 (25---30HP/ 19---22KW) 043334 1
element, heavy duty air filter 040595 (40HP/ 30 KW) 040596 1
element, primary replacement for separator 250034---113 250034-- 114 1
kit, repair for air inlet valve 02250088---348 250019--451 1
kit, repair springs for air inlet valve 02250088---348 250029--315 1
kit, repair for minimum pressure/check valve 02250097---609 250026--758 1
kit, repair cap for minimum pressure/check valve 02250097---609 02250046--397 1
kit, repair o---ring for minimum pressure/check valve 02250097---609 02250048-- 362 1
kit, repair piston for minimum pressure/check valve 02250097---609 02250051-- 338 1
kit, repair thermal valve 02250096---738 (170˚F) 250025--621 1
kit, repair thermal valve 02250103---509 (190˚F) 02250103-- 562 1
kit, repair for pressure regulator 250017---280 250019--453 1
kit, repair for blowdown valve 250025---655 250031--772 1
kit, repair for solenoid valve 250038---674 (<= 140 psi/ 9.7 bar) 250038-- 673 1
kit, replacement for solenoid valve coil 250038---674 (<= 140 psi/ 9.7 bar) 250031-- 738 1
kit, repair for solenoid valve 250038---675 (>140 psi/ 9.7 bar) 02250055-- 939 1
kit, replacement for solenoid valve coil 250038---675 (>140 psi/ 9.7 bar) 250038-- 730 1
kit, repair inlet valve 02250088---348 250019--451 1
kit, repair for v---type strainer 241771 241772 1
kit, repair for shaft seal 001836--007 1
element, replacement for combination separator/trap 02250078---841 02250081-- 108 1
kit, repair automatic drain for combination separator/trap 02250078---841 02250087-- 422 1
manual, Sequencing & Protocol (I) 02250057--696 1
fluid, SRF 1/4000 (5 gallons) 250019--662 (II)
lubricant, Sullube 32 (std.) (5 gallons) 250022--669 (II)
lubricant, 24 KT (5 gallons) 046850--001 (II)
(I) This document is required to program your personal computer to communicate with the Supervisor II
panel.
(II) For proper amount of fluid fill, please consult Lubrication Guide in Section 3, Specifications.
PLEASE NOTE: WHEN ORDERING PARTS, AL WAYS INDICA TE SERIAL NUMBER OF COMPRESSOR

Table of Contents

Related product manuals