Sullair LS-10 series - Page 4

TABLE OF CONTENTS
(CONTINUED)
Section 4
PAGE
INSTALLATION
23
4.7 ELECTRICAL PREPARATION-- SUPERVISOR II
(CONTINUED) 23
4.8 MOTOR ROTATION DIRECTION CHECK
Section 5
OPERATION-
25
5.1 GENERAL
ELECTRO-MECHANICAL
25
5.2 PURPOSE OF CONTROLS-- STANDARD ELECTRO-
MECHANICAL
27
5.3 INITIAL START--UP PROCEDURE-- STANDARD ELECTRO-
MECHANICAL
27
5.4 SUBSEQUENT STAR T--UP PROCEDURE-- STANDARD ELECTRO-
MECHANICAL
27
5.5 SHUTDOWN PROCEDURE-- STANDARD ELECTRO-
MECHANICAL
Section 6
OPERATION-
29
6.1 INTRODUCTION
SUPERVISOR II
29
6.2 KEYPAD
29
6.3 STATUS DISPLAYS
30
6.4 LAMP INDICATORS
31
6.5 OPERATION INTRODUCTION
31
6.6 SUPERVISOR II PARAMETER SETUP
32
6.7 OPERATING THE COMPRESSOR
33
6.8 PURPOSE OF CONTROLS-- SUPERVISOR II
34
6.9 SUPERVISOR II OUTPUT RELAYS
34
6.10 INITIAL START--UP PROCEDURE-- SUPERVISOR II
35
6.11 SUBSEQUENT START--UP PROCEDURE-- SUPERVISOR II
35
6.12 SHUTDOWN PROCEDURE-- SUPERVISOR II
Section 7
MAINTENANCE
37
7.1 GENERAL
37
7.2 DAILY OPERATION
37
7.3 MAINTENANCE AFTER INITIAL 50 HOURS OF
OPERATION
37
7.4 MAINTENANCE EVERY 1000 HOURS
37
7.5 FLUID MAINTENANCE
37
7.6 FILTER MAINTENANCE
37
7.7 SEPARATOR MAINTENANCE
37
7.8 PARTS REPLACEMENT AND ADJUSTMENT PROCEDURES
40
7.9 TROUBLESHOOTING-- STANDARD ELECTRO-
MECHANICAL