TABLE OF CONTENTS
Section 3 PAGE
SPECIFICATIONS 17 3.5 LUBRICATION CHANGE RECOMMENDATIONS AND
(CONTINUED) MAINTENANCE
Section 4
INSTALLATION
23 4.1 MOUNTING OF COMPRESSOR
23 4.2 VENTILATION AND COOLING
23 4.3 SERVICE AIR PIPING
24 4.4 COUPLING ALIGNMENT CHECK
24 4.5 FLUID LEVEL CHECK
24 4.6 ELECTRICAL PREPARATION- STANDARD ELECTRO-
MECHANICAL
25 4.7 ELECTRICAL PREPARATION- SUPERVISOR II
25 4.8 MOTOR ROTATION DIRECTION CHECK
Section 5
OPERATION- ELECTRO-
MECHANICAL
27 5.1 GENERAL
27 5.2 PURPOSE OF CONTROLS- STANDARD ELECTRO-
MECHANICAL
29 5.3 INITIAL START-UP PROCEDURE- STANDARD ELECTRO-
MECHANICAL
29 5.4 SUBSEQUENT START-UP PROCEDURE- STANDARD
ELECTRO-MECHANICAL
29 5.5 SHUTDOWN PROCEDURE- STANDARD ELECTRO-
MECHANICAL
Section 6
OPERATION-
31 6.1 INTRODUCTION
SUPERVISOR II 31 6.2 KEYPAD
31 6.3 STATUS DISPLAYS
32 6.4 LAMP INDICATORS
33 6.5 OPERATION INTRODUCTION
33 6.6 SUPERVISOR II PARAMETER SETUP
34 6.7 OPERATING THE COMPRESSOR
35 6.8 PURPOSE OF CONTROLS- SUPERVISOR II
36 6.9 SUPERVISOR II OUTPUT RELAYS
37 6.10 INITIAL START-UP PROCEDURE- SUPERVISOR II
37 6.11 SUBSEQUENT START-UP PROCEDURE- SUPERVISOR II
37 6.12 SHUTDOWN PROCEDURE- SUPERVISOR II
To Next Page
Loading...
Need help?
General
