Sullair LS-100L - Enclosure- 25-30 Hp; 18-22 Kw Air-Cooled (Odp)

122 pages

To Next Page

To Previous Page

Section 8

ILLUSTRATIONS AND PARTS LIST

02250142-076R04

8.19 ENCLOSURE- 25-30HP/ 18-22KW AIR-COOLED (ODP)

Main Page

Table of Contents3
General7
Personal Protective Equipment7
Pressure Release7
Fire and Explosion8
Moving Parts8
Hot Surfaces, Sharp Edges and Sharp Corners8
Toxic and Irritating Substances8
Electrical Shock9
Lifting9
Entrapment10
Introduction11
Description of Components11
Sullair Compressor Unit, Functional Description11
Compressor Cooling and Lubrication System, Functional Description12
Compressor Discharge System, Functional Description15
Control System, Functional Description- Standard Electro-Mechanical15
Control System, Functional Description- Supervisor17
Air Inlet System, Functional Description18
Instrument Panel Group, Functional18
Specifications21
Lubrication Guide- Standard22
Lubrication Change Recommendations and Maintenance23
Lubrication Guide- 24Kt Fluid23
Application Guide23
Mounting of Compressor29
Ventilation and Cooling29
Service Air Piping30
Coupling Alignment Check30
Fluid Level Check30
Electrical Preparation- Standard Electro-Mechanical30
Electrical Preparation- Supervisor31
Motor Rotation Direction Check31
Purpose of Controls-Standard Electro-Mechanical33
- Initial Start-Up Procedure- Standard Electro-Mechanical35
General33
Subsequent Start-Up Procedure- Standard Electro-Mechanical35
- Shutdown Procedure- Standard Electro- Mechanical35
Introduction37
Keypad37
Status Displays37
Lamp Indicators38
Operation Introduction39
Supervisor II Parameter Setup39
Operating the Compressor40
Purpose of Controls- Supervisor41
Supervisor II Output Relays42
Initial Start-Up Procedure- Supervisor43
Subsequent Start-Up Procedure- Supervisor43
Shutdown Procedure- Supervisor43
General45
Daily Operation45
Maintenance after Initial 50 Hours of Operation45
Maintenance Every 1000 Hours45
Fluid Maintenance45
Filter Maintenance45
Separator Maintenance45
Parts Replacement and Adjustment Procedures45
- Fluid Filter Element Replacement45
- Air Filter Maintenance46
- Separator Element Replacement47
- Control System Adjustment47
- Pressure Regulator Adjustment48
- Drive Coupling Installation and Maintenance48
Troubleshooting- Standard Electro- Mechanical49
Troubleshooting Guide- Standard50
Troubleshooting- Supervisor52
Troubleshooting Guide- Supervisor52
Calibration54
Procedure for Ordering Parts57
Recommended Spare Parts List57
Motor, Compressor, Frame and Parts60
Cooler Assembly64
Air Inlet System66
Air Piping- Air-Cooled68
Fluid Piping- 25, 30 & 40Hp/ 18, 22 & 30Kw Odp70
Fluid Piping- 25, 30 & 40Hp/ 18, 22 & 30Kw Tefc72
Air Piping- Water-Cooled74
Water Piping76
Cooling and Lubrication System78
Air Piping- 40Hp/ 30Kw Water-Cooled80
Water Piping- 40Hp/ 30Kw Water-Cooled82
- Cooling and Lubrication System- 40Hp/ 30Kw Coolers (Water-Cooled)84
- Discharge System86
- Electric Drain Assembly88
- Control System and Electrical Parts90
- Instrument Panel94
- Enclosure- 25-30Hp/ 18-22Kw Air-Cooled (Odp)96
- ENCLOSURE- 25-30HP/ 18-22KW (TEFC); 40HP/ 30KW (ODP and TEFC) AIR-COOLED98
- Enclosure- Water-Cooled100
- Decal Group102
Decal Locations108
Decal Locations- Enclosure112
Wiring Diagram- Electro-Mechanical Full Voltage114
Wiring Diagram- Supervisor Deluxe Full Voltage115
- Wiring Diagram- Electro-Mechanical Wye-Delta116
- Wiring Diagram- Supervisor Deluxe Wye-Delta117
- Wiring Diagram- Electro-Mechanical Wye-Delta Europe118
- Wiring Diagram- Electro-Mechanical Supervisor Deluxe Full Voltage119

Sullair LS-100L - Enclosure- 25-30 Hp; 18-22 Kw Air-Cooled (Odp)

Table of Contents

Related product manuals