Section 7
ILLUSTRATIONS AND PARTS LIST
43
7.3 MOTOR, COMPRESSOR, FRAME AND PARTS
key part
number description number quantity
1 guard, coupling 250007---304 1
2 capscrew, hex gr5 1/2”---13 x 1 1/4” 828608---125 4
3 washer, regular unfinished 1/2” 837208---112 4
4 capscrew, ferry 3/4”---10 x 4” 828412---400 8
5 washer, springlock 3/4” regular 837512---188 16
6 hub, coupling 2 1/4” x 5/8”id
(200HP/150KW) 250007---875 1
S hub, coupling 2 3/4” x 5/8” id
(250HP/187KW) 250004---636 1
S hub, coupling 2 3/4” x 5/8”id
(300HP/225KW) 250004---636 1
S hub, coupling 2 3/4” x 5/8””id
(350HP/261KW) 250004---636 1
7 element, drive coupling 046999 1
8 hub, coupling 2 3/4” x 5/8” 250004---635 1
9 motor, 200HP/150KW 050982 1
S motor, 250HP/187KW 050401 1
S motor, 300HP/225KW 250007---820 1
S motor, 350HP/261KW 250007---903 1
10 capscrew, hex gr5 3/4”---10 x 3” 828612---300 4
11 shim set, motor mounting 020293 4
12 frame, 200HP/150KW 250007---796 1
S frame, 250HP/187KW 250006---714 1
S frame, 300HP/225KW 250006---714 1
S frame, 350HP/261KW 250006---714 1
13 capscrew, hex gr5 3/4”---10 x 1 1/2” 828612---150 4
14 washer, springlock regular 1/2” 837508---125 4
15 nut, hex 1/2”---13 824208---448 16
16 nut, hex 3/4”---10 unfinished 824212---665 8
17 lug, lifting 250008---361 4
18 capscrew, hex gr5 1/2”---13 x 2” 828608---200 16
19 nut, hex 1/2”---13 824208---448 16
20 compressor unit (I) --- ---
(I) There is an exchange program whereby a remanufactured compressor unit can be obtained
from Sullair distributors or the factory at less cost than the owner could repair the unit. For
information regarding the unit exchange program, contact your nearest Sullair representative
or the Sullair Corporation.
The shaft seal is not considered part of the compressor unit in regard to the two year warranty.
The normal Sullair parts warranty applies. For shaft seal repairs consult factory.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
