8.3 MOTOR, COMPRESSOR, FRAME AND PARTS
key part
number description number quantity
1 block, motor adjust base 2” 02250059-262 2
2 motor, 350 horsepower 4160/60 4p tefc (I) 02250064-203 1
3 orifice, .040” x .25m x .25m nptf 02250109-215 1
4 screw, sqhd 0.5 x 3.5 cup set pt 02250112-193 6
5 guard, coupling TS32S center dd adjustable 02250113-561 1
6 guard, coupling l.h. TS32S g.d. adjustable 02250113-562 1
7 guard, coupling r.h. TS32S g.d adjustable 02250113-563 1
8 coupling, flexible disc TS32S 02250115-080 1
9 orifice, cap .031” x 1/4” npt 02250132-934 1
10 frame, main LS32-400a lp 02250141-038 1
11 support, motor LS32-400a lp spcl 02250141-129 2
12 valve, check 1/2” 042694 1
13 block, motor adjusting 222054 2
14 block, motor adjust bse 1-1/2” 230450 2
15 strainer, v-type 300psix1/4 (II) 241771 1
16 disconnect, shrink rfn-4071 250009-242 1
17 elbow, 90deg m swvl 1/4t x 1/4 npt 250025-850 2
18 hub, coupling 3.625” bore (III) 2500339-610 1
19 connector, tube-f 1/4 x 1/4 810104-025 1
20 connector, tube-m 1/4 x 1/2 810204-050 1
21 elbow, tube 90 deg m 1/4 x 1/4 810504-025 2
22 nut, hex pltd 3/4-10 825212-665 4
23 nut, hex pltd 7/8-9 825214-776 4
24 nut, hex f pltd 5/16-18 825305-283 2
25 nut, hex f pltd 3/8-16 825306-347 4
26 capscr, hex gr5 3/4-10 x 4 1/2 829112-450 4
27 capscr, hex gr5 7/8-9 x 4 829114-400 4
28 screw, hex ser washer 5/16-18 x 1/2 829705-050 4
29 screw, hex ser washer 5/16-18 x 3/4 829705-075 2
30 screw, hex ser washer 3/8-16 x 1 829706-100 4
(Continued on page 57)
(I) Motor may vary. Consult factory with machine serial number.
(I) For mainteinance on strainer no. 241771, order repair kit no. 241772.
(III) For maintenance on drive coupling element, order drive coupling replacement no. 046999.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
Section 8
ILLUSTRATIONS AND PARTS LIST
55
To Next Page
Loading...
