Sullair LS-32 - Page 70

118 pages

To Next Page

To Previous Page

Section 8

ILLUSTRATIONS AND PARTS LIST

8.5 FLUID COOLING SYSTEM- AIR-COOLED

02250140-994R00

Main Page

Table of Contents3
General7
Personal Protective Equipment7
Pressure Release7
Safety Information7
Fire and Explosion8
Hot Surfaces, Sharp Edges and Sharp Corners8
Moving Parts8
Electrical Shock9
Lifting9
Toxic and Irritating Substances9
Entrapment10
Description of Components11
Introduction11
Product View and Parts Identification11
Compressor Cooling and Lubrication System, Functional Description12
Rear View12
Sullair Compressor Unit, Functional Description12
Compressor Discharge System, Functional Description13
- Compressor Piping and Instrument Diagram14
- Compressor Cooling and Lubrication System18
Control System, Functional Description18
- Compressor Discharge System19
- Control System21
- Air Inlet System, Functional Description26
- Compressor Air Inlet System26
Application Guide27
Lubrication Change Recommendations and Maintenance27
Lubrication Guide- 24Kt Compressors27
Lubrication Guide- Standard Compressors27
Sullair Series Ls-32 Specifications27
Coupling Alignment Check29
Electrical Preparation29
Fluid Level Check29
- Installation29
- Mounting of the Compressor29
Service Air Piping29
Ventilation and Cooling29
Motor Rotation Direction Check30
- Service Air Piping (Typical Installation)30
- Supervisor Control Panel32
Function Menu33
Main Display33
Supervisor Keyboard Layout33
Control Parameters- Pressure, Temperature, and Timer Settings34
Status- Current Pressures, Temperatures, Inputs and Outputs34
Supervisor Controller34
Maintenance- Preventive Maintenance Information and Timers35
Sequencing- Sequencing & Communication Parameters35
Calibration- Correction Factors for Pressures36
FACTORY SETUP- Model Settings36
System Display- Display of Modes of36
- Machines in a Sequencing System36
Troubleshooting Introduction37
Troubleshooting Guide38
- Supervisor Controller38
  - Alarms40
  - Compressor Operation41
Introduction41
Purpose of Controls41
Initial Start-Up Procedure42
Shutdown Procedure43
- Main Filter Maintenance45
Subsequent Start-Up Procedure43
Daily Operation45
Fluid Change45
General45
Maintenance after 1000 Hours45
Maintenance after Initial 50 Hours of Operation45
Parts Replacement and Adjustment Procedures45
Separator Maintenance45
- Air Filter Maintenance46
  - Air Filter Replacement46
  - Element Inspection47
- Oil Return/Sight Glass Maintenance47
  - Separator Element Replacement47
  - Annual Maintenance - Drive Coupling48
- Compressor Drive Coupling48
Troubleshooting53
Troubleshooting Guide53
- Procedure for Ordering Parts57
  - And 400HP/ 261 and 299KW58
- Recommended Spare Parts List57

Sullair LS-32 - Page 70

Table of Contents

Related product manuals