Section 7
MAINTENANCE
32
592) is located schematically between the thermal
valve on the sump and the oil stop valve on the
compressor-mounting bracket. When servicing this
filter, shut the compressor down, make sure all
pressure has been released, then follow the instruc-
tions below. For element replacement order kit
number 250031-850.
1. Unthread the filter canister from the head. A hex
nut is supplied on the bottom of the canister
along with the bottom portion of the canister has
a rough textured surface. Either can be used to
assist in removal of the canister.
2. Pull the canister away from the filter head. The
filter elements will be attached to the filter head.
3. Separate the element from the filter head.
4. Remove the canister seal.
5. Thoroughly clean the filter head and canister in
solvent.
Figure 7-1 Main Filter (P/N 02250111-592)
*Repair Kit P/N 250031-850
Figure 7-2 Air Filter Replacement (P/N 048456)
*Replacement Element P/N 02250135-150 (primary)
**Replacement Element P/N 048463 (secondary)
To minimize the possibility of filter element rup-
ture, it is important that ONLY replacement ele-
ments identified with the Sullair name, logo and
appropriate part numbers be used, and that sub-
stitute elements NOT be used, due to the fact that
such filters may have inadequate or questionable
working pressure ratings.
To Next Page
