02250236-267 R02 Subject to EAR, ECCN EAR99 and related export control restrictions.
1. Carry out the electrical work according the local and
national electric codes and standards. All electrical work
shall be done by a licensed electrician.
2. Install a circuit protection according to the local and
national electric codes and standards. Breakers and
fuse disconnect are permitted.
1. Internal air compressor wiring has been
completed prior to shipment from the
factory.
2. Remove the front panel, open the door
to the starter panel and connect the
main power supply cable to the
terminal block.
Installation(continued)
8
● Verify that the power supply for the facility corresponds with the power supply of the air
compressor.
Failure to adhere to this precaution may lead to starting failure, electric motor failure and/or damage to the air
compressor.
● The SRL air compressor should be wired per the local and national electric codes. Improper wiring
may lead to excessive voltage drops.
● Do not use a generator.
CAUTION
5 Wiring the Air Compressor
Connecting the Main Power
Wiring the Air Compressor
Terminal
Block
Main Power
Supply Cable
Tighten the nut after
connecting the power
cable.
Earth Leakage (Ground)
Circuit Breaker
Front panel
To Next Page
Loading...
