02250236-267 R02 Subject to EAR, ECCN EAR99 and related export control restrictions.
Installation
4
● It is recommended that properly trained personnel move the air compressor.
● Operation of the air compressor with the transport fixtures installed will lead to excessive vibration
of the air compressor and the package may rupture. The transport fixtures must be removed prior
to operation of the air compressor.
WARNING
1 Product Confirmation
1. Check the air compressor nameplate to verify that
the proper model air compressor was delivered.
2. Verify that there has been no damage to the air
compressor during transportation.
3. Verify that the items shown below are included
with the air compressor.
Rubber
vibration
sheets for
installation -
4 Sheets
User
Manual
1 copy
4 - Steel
plates
＆ 8 - Bolts
Model Nameplate
● Review the model
number, serial number,
power requirements and
compressor
specifications.
● Do not use an air compressor with
a power supply differing from the
specified power requirement.
Incorrect power supply may cause
a thermal event and/or abnormal
vibration.
CAUTION
2 Transporting the Air Compressor
Transporting the Air Compressor Removing the Transport Fixtures
Moving with a Forklift
Place a buffer plate
between the air compressor
and the forklift to protect
the air compressor panels.
Do not tilt the forks of
the forklift too much. Too
much tilt may cause the air
compressor to drop.
Remove the transport fixtures
Bolt
Fixture
Transport Fixtures Location
● After installing the air compressor,
attach the plates shown in the figure
to the right.
These plates are shipped with the
compressor and will greatly reduce
compressor noise during operation.
【 R efe re n c e】
● Open the front door, remove the yellow bolts and
remove the transport fixtures prior to operation.
7.7/11kW : 2 locations
16.5kW : 3 locations
USER MANUAL
Oil Free Scroll Compressor
SRL-7.5MB, SRL-11MB, SRL-16.5MB
Users are required to read
the entire User Manual before
handling or using the product.
Keep the User Manual in a safe
place for future reference.
SAFETY WARNING
Failure to follow the instructions
and procedures in this manual,
or misuse of this equipment, will
void its warranty.
WARRANTY NOTICE
10 – 22 hp (7.5 – 16.5 kW)
PART NUMBER:
02250236-267 R01
The information in this manual is current as of its
publication date and applies to compressor models
indicated on this cover until next revision of this manual
or release of a replacement manual.
Publication date: 04/01/2018
Copyright © 2017 – 2018 Sullair, LLC. All rights reserved.
Subject to EAR, ECCN EAR99 and related export control restrictions.
To Next Page
Loading...
