Sullair SUPERVISOR CONTROLLER User Manual

SECTION 1
4
C. Attempt repairs in clean, dry and well lighted and
ventilated areas only.
D. DO NOT leave the compressor unattended with
open electrical enclosures. If necessary to do so,
then disconnect, lock out and tag all power at
source so others will not inadvertently restore
power.
E. Disconnect, lock out, and tag all power at source
prior to attempting repairs or adjustments to
rotating machinery and prior to handling any
ungrounded conductors.
1.4 DECALS
See Figure 1-1. The Supervisor control panel
contains several decals which contain necessary
information for safe performance. These decals
should never be removed. If a decal becomes
damaged, contact your nearest Sullair Department
for replacement parts (Note: When ordering new
decals, use part number printed on decal face).
DANGER
All field equipment must be tested for elec-
trostatic fields prior to servicing or making
contact with the machine using the follow-
ing or equivalent test equipment:
• 90-600 VAC: Volt detector such as
Fluke Model 1AC-A
• 600-7000 VAC: Voltage detector
such as Fluke Networks Model
C9970
It is the responsibility of each organization
to provide/arrange training for all their
associates expected to test for electrostatic
fields.

Sullair SUPERVISOR CONTROLLER Specifications

General

Brand	Sullair
Model	SUPERVISOR CONTROLLER
Category	Controller
Language	English