WSPC USER INTERFACE MANUAL SECTION 4
22
STATUS BAR COMPONENTS
Listed below is the information that is displayed in the
fields of the Compressor Status Bar.
Compressor Operating Mode—The Operating
Mode is the manner in which the machine operation
is being controlled. There are five Operating Modes:
AUTOMATIC, MANUAL, OFF, FAULT, and UI
COMM.
Operating State—The state of the compressor
operation in response to the current mode and
current conditions. The operating state essentially
describes what the machine is currently doing.
Compressor Temperature 1—The internal
temperature of the compressor.
Sump Pressure—The compressor sump pressure.
Line Pressure—The discharge pressure of the
compressor.
Control Volts—The actual voltage of the
compressor control supply.
Additional data may be displayed in the Compressor
Status Bar depending on user access level and
machine configuration. These include dryer dewpoint
temperature and spiral valve modulation indicators.
4.2 COMPRESSOR DATA
DISPLAY (DEFAULT
SCREEN)
The “Compressor Data” display is the window that
appears when the WSPC Interface is initialized. See
Figure 4-2. If the Compressor Data display is not
showing on the monitor, access the display by
clicking on the “Compressor Data” tab. At this display
the user can monitor compressor operating
information.
Figure 4-2: Compressor Data Display
To Next Page
Loading...