Sullair WSPC - Page 37

SECTION 4 WSPC USER INTERFACE MANUAL
37
LOADING PARAMETER SETTINGS
At the “Machine Profiles” window, control parameters
from a saved profile can be loaded to the WS
Controller. The values stored in the saved profile will
replace the parameter values displayed on the
Adjustments display. When an adjustment register is
loaded, the new parameter values become
immediately effective at the WS Controller.
To load a saved Machine Profile:
1. Access the “Adjustments” display by clicking
on the “Adjustments” tab.
2. Click the Load/Save button on the “Adjust-
ments” display (Figure 4-17).
3. Click on the Name of the saved machine pro-
file to be loaded. Saved Machine Profiles are
listed in the lower portion of the Machine
Profiles window. The control parameter val-
ues for the selected profile will be shown in
the upper portion of the window. These val-
ues are presented for reference only and
cannot be edited.
4. Click “Write to Controller” to load the param-
eters of the selected profile to the WS Con-
troller. The parameters will immediately
become active at the controller and the com-
pressor and/or compressor system will begin
operating using the new parameter values.
Figure 4-18: Machine Profiles Window