WSPC USER INTERFACE MANUAL SECTION 5
40
Controller and the WSPC software can be
viewed and modified as necessary. All four
must be set properly for the programs to
communicate. The following communication
parameters can be adjusted from the User
Profiles window:
Modbus Address—displays the modbus
communication ID. The default modbus ID
value is 1 in the WS Controller, but is adjust-
able.
Com Port—This is the PC’s communication
transmission channel through which data is
passed to and from the computer.
Baud Rate—The communication speed in
bits per second between the WS Controller
and the PC interface. RS232 communica-
tions of the WS Controller is always 38400
Baud. RS485 is 19200 Baud by default, but
is adjustable.
Parity—The method used for checking the
accuracy of the flow of data between the
computer and communication devices. The
parity setting helps to determine if a trans-
mission error has occurred between devices.
RS232 communications of the WS Controller
is always “None.” RS485 communication is
“Even” by default, but is adjustable.
When done viewing the profile settings, click
cancel to exit the profile window. The “Enter
Password” option box will be presented. See
Figure 5-3.
9. Select a profile and click OK to make the
profile active.
Figure 5-2: User Profiles Window
To Next Page
Loading...