SECTION 5 WSPC USER INTERFACE MANUAL
41
E
DIT A PROFILE
To edit an existing profile:
1. Click “File” on the menu bar.
2. Select “Profiles”. The User Profiles window
will be presented showing the settings for the
current profile.
3. Select a profile for editing from the list in the
lower portion of the User Profiles window.
4. Click “Edit” to allow editing of the profile on
the upper part of the scrren.
5. Change the profile name” by entering a new
name in the “User Name” field. See Figure 5-
4.
6. In the “Notes” field, enter a brief note relating
to the compressor system.
7. In the “Language” field, click on the drop
down arrow and select the desired language
for the WSPC software.
8. Select the desired “Units of Measure.” These
settings determine the units of measure to be
displayed by the WSPC software. Units
selected here will not affect units displayed
on the WS Controller user interface.
a. At the “Pressure” field, click on the drop-
down arrow and select the pressure unit
as PSI, Bar, or Kpa.
b. At the “Temperature” field, click on the
drop-down arrow and select the temper-
ature unit as Deg F or Deg C.
c. At the "Flow" field, click on the drop-
down arrow and select the air flow unit
as ACFM, M3/hr, M3/min, L/min, L/sec.
d. At the "Power" field, click on the drop-
down arrow and select the power unit as
KW or HP.
e. At the "Volume" field, click on the drop-
down arrow and select the volume unit
as KCF, Feet3, Gallons (US), Liters, M3,
and KM3.
9. Select the desired “Communication Port”
settings. These settings control communica-
tion between the WS Controller and the
WSPC software.
a. At the “Modbus Address” field, click the
up/down arrows to increment to the
required modbus communication ID. The
default modbus value is set to 1. This
number should be changed only if the
modbus interface has been configured
for a different port.
b. At the “Com Port” field, enter the number
of the communication port to use for con-
necting to the PC. There are 16 com port
options listed. The actual number of com
ports available will vary depending on
the computer system being used. The
default Com Port is set to 1
Figure 5-3: Select Profile (Password Box)
NOTE
The Modbus Address, Baud Rate, and
Parity assigned here must
match the
modbus parameters of the controller. If
the settings do not match, communica-
tion between the PC and the controller
will not occur.
To Next Page
Loading...