SECTION 7 WSPC USER INTERFACE MANUAL
55
3. Click the down arrows for the machine model
for which the controller is to be commis-
sioned. See Figure 7-3.
4. After the Model has been chosen, select the
attributes that apply to the specific machine
being commissioned. Only those options that
have multiple choices may be selected.
a. Click “Hp” to select the horsepower of
the compressor motor.
b. Click “Hz” to select the compressor
motor frequency.
c. Click “Pressure” to select the compres-
sor pressure rating.
d. Click “Cooling” to select the compressor
cooling method.
e. Click “Motor” to select the compressor
motor phase type.
f. Click “Volts” to select the compressor
operating voltage.
g. Click “Dryer” to select the compressor
dryer type.
5. When all appropriate attributes have been
selected, click “OK”. The program will pres-
ent a “Continue to Commission” option box.
See Figure 7-4.
6. Click “Yes” to confirm commissioning the
controller to the selected compressor model.
Commissioning will begin and the progress
of the commissioning process will be shown
in the commissioning window. See Figure 7-
5.
7. As the default settings are loaded to the con-
troller, a commissioning progress meter will
be presented to allow the administrator to
monitor the progress of the commissioning
process. When the default settings have fin-
ished loading to the controller, a final confir-
mation box will appear indicating that
commissioning is complete (Figure 7-6).
NOTE
Use care to select the proper machine
model. All machine attributes must match
the model selected during commissioning
to ensure proper and safe operation.
Figure 7-3: Commission Select
Figure 7-4: Commissioning Confirmation
To Next Page
Loading...