WSPC USER INTERFACE MANUAL SECTION 7
66
SAVING AND LOADING ADMINISTRATOR
PARAMETERS
Administrator parameters may be Saved and loaded
by using the Load/Save button on the “Admin” tab.
The procedures are identical to those described for
User Adjustments in Saving Parameter Settings on
page 36 and Editing and Searching Machine Profiles
on page 36.
IMPORT COMMISSION DATA
The commissioning parameters will be updated from
time to time as new models or features are added to
the line of compressors. When this happens, a
commission data text file will be distributed. This
allows easier distribution, including simple e-mail
attachments. It also will allow the update without
affecting other WSPC preferences and saved
information. The procedure is simple and fast, and
should be done following any distribution from
Sullair.
1. Copy the new file to your PC. The preferred
location is with the other WSPC program
files. You may use “Import Other Data” to
copy files from other locations to this folder.
2. Start WSPC. You do not need to be con-
nected to a controller.
3. Select the “Admin” tab.
4. Click the “Import Commission Data” tab.
5. Select the file with the new commission data.
See Figure 7-15. You may browse to other
locations, if necessary.
6. Click the “Open” button
7. Confirm or Cancel on the confirmation box.
All old commissioning data is cleared when
you confirm.
8. Wait while the data is updated. This takes
about a minute.
9. A final confirmation box will confirm that the
job is completed.
Figure 7-15: Import Data Screen
To Next Page
Loading...