715
English
CONTROL PANEL
Paper – indicates that
the machine is set to
compact paper and
cardboard.
The machine operates
using high pressure.
Plastic – indicates that
the machine is set to
compact plastic. The
machine operates using
low pressure. See
Technical specications
for more details. Do not
use the “Paper” setting
when compacting plastic.
This may damage the
machine. If the machine
is set to plastic and MAN
mode when a press cycle
is run, the press plate will
remain pressed down
against the waste for 30
minutes (default).
Bale size - indicates the
selected bale size (small
– medium – large).
The bale size can be
xed. Contact your local
distributor for more infor-
mation.
Up arrow - used to
raise the press plate to
its normal position.
Down arrow - used to
lower the press plate.
The press plate stops
UNDER PRESSURE
against the bale in its
down position (in the
case of manual bale
removal).
Start - starts a com-
paction cycle (in
the case of manual
starting).
Steady light: the ma-
chine is ready for use.
Blinking light: the
upper door must be
opened and closed for
the press cycle to be
able to start.
Emergency
stop - used if a
compaction cycle
has to be stopped
immediately.
Bale light - this
light goes on when
the bale is ready to
be removed from
the machine.
Service light - the
machine can continue
to be operated, but
authorised service
personal should be
contacted.
MAN - indicates that
the machine is set for
manual starting. To start a
compaction cycle, the start
button must be pressed.
AUTO - indicates that
the machine is set for
automatic starting. This
means that the machine
will automatically start a
compaction cycle when the
upper door is closed.
Temperature lights
Blue lights indicate that the
machine is cold. The machine can
still be operated.
Red light indicates that the machi-
ne has overheated and CANNOT
be operated until it has returned
to its normal temperature and the
light has gone out.
Voltage light - this
light indicates that
the machine is
supplied with power.
RANGE OF APPLICATION
The machine is a hydraulically operated baler intended for compacting bulky materials such as cardboard, paper and
plastic. The machine may only be used in areas that have a roof, protection against wind, and normal lighting. The machine
is intended for use within the temperature range -10°C to +40°C. A low-temperature oil and/or heater should be used at
temperatures lower than +5°C.
Materials that are ammable or of an explosive nature, such as pressurised containers or the like, which could cause
injury, damage, re or an explosion if exposed to pressure or sparks, must not be compacted in the machine.
To Next Page
Loading...
Need help?
General