A
B
10A
M
i
n
0
,
6
m
M
i
n
0
,
6
m
Svetsaregatan 4
576 33 Sävsjö
Sweden
Type
Serial No
Product No
Date
V
Weight
Hz
kW
A
*
* *
***
Temperature range of use (special oil): -10°C to +40°C
Temperature range of use (standard oil): +5°C to +40°C
~
A
+40 °C
+5 °C
-10 °C **
**
1
2
3
4
5
7
6
MAX
MIN
Oil-
level
4-6 mm
17
917
English
INSTALLATION
NOTE! During inspection and maintenance, servicing and the removal of trapped waste
etc:
1. Set to manual mode (MAN) on the control panel.
2. Disconnect the power to the machine by removing the plug from the wall socket.
3. Do not work inside the machine.
WEEKLY INSPECTION AND MAINTENANCE
SAFETY CHECKS
- Check the shutter switch: it must not be possible to start the machine if the upper shutter is open/opened.
- Check that the emergency stop is working.
- Check that all covers and guards are intact.
- Check that there are no oil leaks on the machine.
- Check that the electrical supply cable is intact and properly protected against impact.
If any faults are discovered in the functions listed above, the machine must not be used until it has been
repaired by authorised service personnel.
Servicing and repairs must only be carried out by qualied and competent personnel, and in accordance with
the machine manufacturer’s instructions.
The service light will come on when the machine requires servicing. Contact authorised service personnel.
When changing the oil: Contact the local authorities for guidance regarding the environmentally correct dis-
posal of waste oil. Miscibility must be taken into account when changing and/or topping up the oil. The machine
comes lled with mineral oil from the factory.
TROUBLESHOOTING:
First, check:
OVERLOAD PROTECTION
NORMAL TRIPPED
FUSE
To Next Page
Loading...
Need help?
General