Sun Microsystems Ultra 5 - Page 22

20 Sun Ultra 5/10 Product Notes • April 1998
Note – The serial port A diagnostic will stall if the TIP line is installed on serial
port A.
CODE EXAMPLE 11 identifies the serial port A output message when the TIP
line is installed on serial port A.
SUBTEST='internal_loopback'
BAUDRATE='19200'
SUBTEST='internal_loopback'
BAUDRATE='38400'
SUBTEST='internal_loopback'
BAUDRATE='57600'
SUBTEST='internal_loopback'
BAUDRATE='76800'
SUBTEST='internal_loopback'
BAUDRATE='115200'
SUBTEST='internal_loopback'
BAUDRATE='153600'
SUBTEST='internal_loopback'
BAUDRATE='230400'
SUBTEST='internal_loopback'
BAUDRATE='307200'
SUBTEST='internal_loopback'
BAUDRATE='460800'
SUBTEST='internal_loopback'
Enter (0-12 tests, 13 -Quit, 14 -Menu) ===>
CODE EXAMPLE 11 Serial Port A Output Message with TIP Line Installed
Enter (0-12 tests, 13 -Quit, 14 -Menu) ===> 7
TEST='uarta_test'
'UART A in use as console - Test not run.'
Enter (0-12 tests, 13 -Quit, 14 -Menu) ===>
CODE EXAMPLE 10 Serial Port A Output Message (Continued)