Sunbeam CAFE DUO - Customisable - extraction pre-infusion profile; Selecting Pre-infusion Profiles

21
Customisable - extraction pre-infusion profile
You can select from three pre-infusion
profiles to cater for personal preferences.
- Gentle pre-infusion: Small defined
amounts of water are introduced into
the tamped coffee grinds, gently adding
moisture to bloom the coffee grinds in
preparation for a steady water flow.
This delivers a balanced tasting espresso.
This is the default profile setting.
- Constant pre-infusion: Delivers a
constant, steady water flow from start to
finish.
For a more sharp tasting espresso.
- Progressive Pre-infusion: A single
distinct dose of water is released into the
tamped coffee grinds, followed by a brief
rest period, then a steady water flow.
For a more bright tasting espresso.
- Customise pre-infusion profiles
- Ensure the machine is plugged in and
switched on at the power outlet.
- Do not press the STANDBY button.
- Press and hold down the MANUAL and 1
CUP buttons.
- While holding down the MANUAL and 1
CUP buttons, press the STANDBY button
and then release both the MANUAL and 1
CUP buttons.
To indicate you have activated the
pre-infusion mode, a light on one of the
buttons will illuminate.
- Press and release one of the buttons
below depending on pre-infusion profile
preference:
- Constant pre-infusion: press the
MANUAL button
- Gentle pre-infusion: press the 1
CUP button
- Progressive pre-infusion: press
the 2 CUP button
- When the new pre-infusion profile has
been selected, the machine will beep
twice.
- The machine will then automatically
power on.
Restore to default shot volumes
To restore to factory settings:
- Ensure machine is plugged in and switched on
at the power outlet.
- Press and hold the MANUAL button.
- While holding the MANUAL button, press the
STANDY button and then release the MANUAL
button.
- The machine will beep 4 times and power on.
Note: Do not press the STANDY button.
CONSTANT
PREINFUSION
GENTLE
PREINFUSION
PROGRESSIVE
PREINFUSION