Sunbeam CAFE DUO - Lets get you started; Initial Setup and Priming Procedure

Everything you need to know after
unboxing your new coffee machine.
Step 1. Remove packaging
- Ensure all packaging has been removed.
Step 2. Position machine
- Ensure the machine is positioned onto a
dry, stable, flat and horizontal benchtop.
Step 3. Wash and dry parts
- Wash the parts listed below in warm
water with a mild detergent:
- Milk jug
- Tamper
- Measuring spoon
- 1 and 2 cup 58mm single wall filter
baskets
- 1 and 2 cup 58mm dual wall filter baskets
- Water tank
- Group handle
- Rinse and allow thorough air drying.
Step 4. Place accessories
- Place the accessories underneath the
water tank lid: 1 and 2 cup single wall
filter baskets, 1 and 2 cup dual wall filter
baskets and cleaning disc.
- Place the tamper on the warming plate.
Step 5. Preparing to prime machine
• Fill water tank
- Remove the water tank from the back or
fill directly from the top water tank lid.
- Fill with cold filtered water.
- Insert the tank into position or close the
water tank lid.
• Power
- Ensure that the steam and hot water
- Insert the power plug into a 230-240V AC
power outlet and switch the power on.
- Press the STANDBY to turn on the
machine.
- Press the STANDBY button will
illuminate and pulse to indicate the
Thermoblock is heating up.
- When the STANDBY, MANUAL, 1 CUP,
2 CUP buttons are fully illuminated, the
machine is ready to use.
8
Let's get you started
Important: This priming step must be
completed prior to first use or if the
machine has been inactive over a long
period of time.
Note: Make sure that the water tank is
clean and free of any debris, as any fine
particles can block the water flow.
Note: When the machine is low on water,
it'll beep and let you know.