Sunbeam CAFE DUO - Page 9

• Insert group handle
- Insert the 2 CUP filter basket in the
group handle.
- Align the group handle with the 'INSERT'
position located on the left of the group
head.
- Insert the group handle flat against the
group head, then turn the group handle
right all the way to the centre position.
Step 6. Prime espresso machine
- Press the 2 CUP button and water
should start flowing from the group
head.
- Allow water to run through until it stops.
- The machine will return to the READY
state.
- Position steam wand over the drip tray.
- Rotate steam lever to ON position.
- Allow steam to run through for 20 sec.
- Return steam lever to OFF position.
- Now the espresso machine should be
thoroughly primed.
- Wash group handle, milk jug and filter
baskets in warm water and dry before
making your first coffee.
- If water is not flowing from the group
head or steam wand, repeat Step 6.
- If water is still not running through,
contact Sunbeam Customer Care.
Details are on the back page.
9
Let's get you started
Note: Turning the group handle to the
centre position might be tight for the
first few uses.
Note: For the first few seconds the pump
will make a louder than usual noise as it
begins pumping the water through.