SunBeat 5010A - User Manual

Questions and Answers

K
kristinchavezAug 7, 2025
Why does my SunBeat Storage have a short discharge time?
- C
  Corey CoxAug 7, 2025
  A short discharge time in your SunBeat Storage can be due to several factors: * **Low battery power:** Ensure the product is charged for more than 4 hours until fully charged. * **Product overload:** Check the load status and remove any non-critical products. * **Battery aging:** If the battery is old, its capacity may have declined. Contact the supplier to replace the battery and its components.
S
Stephen MartinAug 13, 2025
What to do if my SunBeat 5010A Storage is unable to charge and discharge?
- J
  Justin CollinsAug 13, 2025
  If your SunBeat Storage is unable to charge and discharge, consider these possible causes: 1. **Internal failure:** Please contact the supplier. 2. **Charge or discharge protection failure:** Refer to the battery indicator function status table to identify the cause. 3. **SOC protection:** If the battery discharged to the SOC protection value, charge it to the restart SOC value (default 50%). 4. **Battery over temperature:** Allow the battery to cool at room temperature for over 3 hours.
G
Gail MartinezAug 19, 2025
How to fix a SunBeat 5010A that doesn't respond when the start button is pressed?
- A
  Ashley RiveraAug 19, 2025
  If your SunBeat Storage doesn't respond when you press the start button, it could be due to a damaged or poorly installed one-button start wire. To address this, open the side door, close the POWER button on each battery module, and check the turned on status. If that doesn't work, contact the supplier.
N
Nathan DavisAug 25, 2025
What to do if SunBeat 5010A Storage shows battery over temperature?
- B
  Benjamin YoungAug 26, 2025
  If your SunBeat Storage indicates the battery is over temperature, allow it to stand at room temperature for more than 3 hours.
C
cdunnAug 31, 2025
How to troubleshoot a red light failure prompt on SunBeat Storage?
- D
  Denise MillerAug 31, 2025
  To troubleshoot a red light failure prompt on your SunBeat Storage, check the indicator function status table using the prompted fault information to determine the cause.